buffer amplifiers造句

• It is common for a single package to contain several discrete buffer amplifiers.
• A second improvement is the integration of an optional-use output buffer amplifier to the chip on which the OTA resides.
• To provide isolation and prevent ground loops, outputs may be connected via a splitting transformer or a number of buffer amplifiers.
• Because of its high input impedance and easily selectable gain, an operational amplifier in a conventional source followers are other common choices for the buffer amplifier.
• Active splitters with buffer amplifiers ( also known as a distribution amplifier ) are the only solution to provide an unlimited number of splits, but are costly.
• A practical implementation would require the use of buffer amplifiers ( to avoid distorting the previous stage's response ) and, of course, a finite number of stages.
• Voltage and current gain sufficient for + 20dBm into 150 ohms was provided by the output-buffer amplifier which signal was then output at the XLR connector on the DTR's rear panel.
• For example, a "'hex buffer "'is a single package containing 6 discrete buffer amplifiers, and an "'octal buffer "'is a single package containing 8 discrete buffer amplifiers.
• For example, a "'hex buffer "'is a single package containing 6 discrete buffer amplifiers, and an "'octal buffer "'is a single package containing 8 discrete buffer amplifiers.
• To retrieve data from the EPROM, the address represented by the values at the address pins of the EPROM is decoded and used to connect one word ( usually an 8-bit byte ) of storage to the output buffer amplifiers.
• :I would expect the input to output of a VCR to include a powered buffer amplifier . ( The phrase " common collector " comes to mind, or some reason ) . talk ) 04 : 57, 5 June 2009 ( UTC)
• A non-linear buffer amplifier is sometimes used in digital circuits where a high current is required, perhaps for driving more gates than the normal fan-out of the logic family used, or for driving displays, or long wires, or other difficult loads.
• It is common to drive valve power amps directly from such source, using passive volume and input source switching integrated into the amplifier, or with a minimalist " line level " control amplifier which is little more than passive volume and switching, plus a buffer amplifier stage to drive the interconnects.
• An "'instrumentation "'( or "'instrumentational "') "'amplifier "'is a type of differential amplifier that has been outfitted with input buffer amplifiers, which eliminate the need for input impedance matching and thus make the amplifier particularly suitable for use in measurement and circuit both short and long-term are required.
• :In general, the IEEE 1284 compliant devices are very hot-pluggable-though watch out for devices that use a common ground / common live voltage in " unconventional " ways ( other than setting a reference-in theory, there should be buffer amplifiers if the 5-volt is used for anything, but some talk ) 17 : 32, 30 September 2009 ( UTC)